Most Ford Ranger pick-ups come geared up with two pairs of 6 x 8-inch speakers, one in every front door, and a pair situated in the rear panels on the rear of the interior compartment. Although 6 x 8 inches is the official Speaker dimension, most 5 x 7-inch speakers will match in the manufacturing unit gap with no modification required. Many Ranger owners prefer to interchange the manufacturing unit audio system with 6.5-inch round speakers to increase sound quality. To do that, gentle fabrication could also be required.
Ford Ranger Speaker Installation Instructions
1. Remove all door screws, window crank (if outfitted), door handle and any other obstruction from the door panels. The Ford Ranger makes use of a combination of screws and plastic clips to secure the door panel to the door. In some mannequin years, the clips are designed to tug straight out, and in others the door panel must be pulled straight up to release the panel.
2. Take away the screws securing the factory audio system to the door. Disconnect the manufacturing unit Speaker wires by miserable the plastic release tab on the harness and remove the speaker.
3. Reduce the plastic plug off of the top of the Speaker wires, leaving at the least 1 inch of of wire remaining on the plug in order that it might be reattached at a later time if necessary. Use wire crimpers to attach female spade terminals to wire ends and connect the wires to the alternative speaker.
4. Secure the speaker to the door with the factory screws when possible. Roll the window up and down to examine for clearance. If mandatory, a spacer could also be added to offer extra clearance when depth is an issue.
5. Replace the door panel and check for clearance between the speaker and the door panel. Replace the door panels mounting hardware and re-attach the window crank.
6. Turn on the stereo and listen. Guantee that all speakers are playing. Use the stereos steadiness and fade functions to ensure proper connections. Regulate the stereo’s equalizer to your private taste.