A car window regulator is the gadget that makes it doable in your Power Windows to go up and down. Your power window regulator might or might not should be changed often, relying upon the age of your vehicle. Because the First-Generation Ford Focus was first produced in 1999, the power window regulators on these Focuses could also be sporting out and can quickly have to be replaced. Changing the regulator generally is a very time-consuming activity, however you don’t need any specialized tools to complete the job.
Ford Focus Power Window Regulator Installation Instructions
1. Take away the door panel. The door panel in the Focus is held on by a number of clips. Gently pull the panel off of the door, so you don’t break the clips. Hold onto the door panel and do not let it drop; this might damage a number of the wiring inside the door. Gently unhook the wiring from the elements inside the door. There might be wiring attached to your Power Window mechanism, your power lock controls, and your stereo speaker. Lay the door panel to the facet with the screws or clips, so you can find them later.
2. Take away your stereo speaker from inside the door. The speaker in your Focus is held into the door by several screws; merely loosen them and remove the speaker. Gently disconnect the wiring from the back of the speaker, and place the speaker and screws to the side.
3. Take away the window glass from the within of the door. As you do that, you will want to be sure to are supporting the window glass from the bottom as you slide it up and out of the door, so it would not slip and break. You may need to have a buddy make it easier to with this.
4. Pull the window glass out of the door, and put it in a safe place. This will enable you to achieve the window motor and regulator.
5. Unplug the wires from the window motor. You will have to take away the screws from the power window motor and regulator. Then, take away the window motor and regulator to make means for the new parts.
6. Set up the brand new power window regulator. Place the brand new window motor and regulator in place, and exchange the screws that held them in place.
7. Exchange the window glass, and connect it to the power window motor and regulator assembly. Again, it’s possible you’ll need to have a buddy assist you in the course of so you don’t damage your window glass.
8. Replace your stereo speaker and reconnect the wiring to the speaker. Reconnect the wiring for the ability home windows and locks, and change the door panel, ensuring to reinstall the screws that hold the components together.